How to use plugs from Okinawa in Cook Islands
Plugs, sockets, adapters and other information needed for travelling from Okinawa to Cook Islands in this page. If you want a report for other countries, re-start the wizard to find to electric adapters for your trip here.
Quick Chart at-a-glance
|Plugs Type:||A, B, I.||I.|
If you are an electrical savvy, perhaps the previous chart is all you need. If this is not the case, you can continue reading and discover what the chart is saying!
Plugs and Sockets at each country
In Okinawa the following plugs are used: (and Southern Okinawa-hontō, Motobu Peninsula, Northern Okinawa-hontō, Naha.)
|Plug Type A||Plug Type B||Plug Type I|
|Outlet Type A||Outlet Type B||Outlet Type I|
Considerations for Japan
Users living in Japan have commented us the outlets type "B" are not common, therefore plugs type "B" might not be easy to plug in Japan.
... and in Cook Islands you will use: (and Avarua.)
|Plug Type I|
|Outlet Type I|
Rainforest in Cook Islands
Take care: Cook Islands uses higher voltage than Okinawa
Your electric devices from Okinawa will be expecting 100 Volts, but Cook Islands grid is of 240 Volts, this is a substantial difference that requires you to take some extra steps in preparation to your trip:
On the positive side, nowadays many devices will switch automatically to the network voltage and they will work just fine, i.e. mobile phone chargers are typically multi-voltage (but please, do actually check your own). It is important that you pay attention to your device's voltage. Connecting electronics to the wrong voltage, in the luckiest of the cases, the device will break or stop working temporarily; but please don't take this lightly, in the worst of the cases electrocution and fire hazards are a real possibility.
An automatic power supply suitable from 100 Volts to 240 Volts.
High-power devices don't usually handle different voltages due to the high-currents involved i.e. anything that its main purpose involves generating heat (or cold) like hair driers, baby bottle warmers, kettles, etc. On the contrary, modern low-power devices are likely to auto-detect and auto-adapt to different voltages i.e. usb chargers, laptop chargers, etc.
An hair-dryer can consume up to 2000 Watts, like the one in the picture above, due to the high power they usually work in one voltage system; this one is suitable for 220-240 Volts systems.
You will need a step down voltage converter a device that can be plugged to 240 volts and it provides an outlet with 100 volts for your Okinawa' device. You will need to pay attention to the maximum power output of the converter and the maximum power consumption of the device.
Some connectors are used in both countries
You will be able to plug the devices directly in Cook Islands (please read other sections of this reports in regards to voltage, etc.). Perhaps you will need adapters for some sockets, but it is usually easier to find adapters at destination if your plug is already being used in the country. Sometimes different cities uses different systems, you might need to do a bit more of research. If you find more information please let us know.
Lists of adapters you can use in your travel:
This adapter allows you to use plugs type: A, B, C, D, E, F, G, M into outlets type: I.
This is a very cheap adapter without loose terminal and finger protection; it does have earth pass-though (good); but no good grip because of so many different supported plugs. We recommend to use a more expensive option if available.
No equal Hertz
This is not a big issue. Unless you are using an electric alarm clock or some motors when speed is an issue. Explanation: Some alarm clocks uses the frequency of electricity network to measure time. So, time shifts could be experimented. Almost every home electronic device works perfectly with different Hertz.